Melt Indexer

		Melt Indexer MI-1 The Melt Indexer MI-1. This basic melt indexer can carry out a single weight test according to ISO 1133 and ASTM D1238, procedure A, as well as ISO 1133 and ASTM D1238 Procedure C for the "Half Height / Half Diameter" standard.

		Melt Indexer MI-2 The Melt Indexer MI-2. This unique melt indexer can carry out a single weight test according to ISO 1133 and ASTM D1238, procedures B, as well as ISO 1133 and ASTM D1238 Procedure C for the "Half Height / Half Diameter" standard.

		Melt Indexer MI-3 The Melt Indexer Model MI-3. This unique melt indexer can carry out a single weight test according to ISO 1133 and ASTM D1238, procedures B, as well as ISO 1133 and ASTM D1238 Procedure C for the "Half Height / Half Diameter" standard.

		Melt Indexer MI-4 The Melt Indexer Model MI-4. This unique melt indexer with automatic weight selection can carry out a single weight test according to ISO 1133 and ASTM D1238, procedures B, as well as ISO 1133 and ASTM D1238 Procedure C for the "Half Height / Half Diameter" standard. Tests can be made either with one test load (single load mode) or with several test loads per barrel filling (multiple test load mode).

		MI-Cleaning Boy The MI-Cleaning Boy, a Melt Indexer with fully automated Ceaning Station.

		Fully Automatic Melt Indexer MI-ROBO A new generation of the fully automated melt indexer. Pellets, powders and similar shaped materials an now be run and cleaned with one device.

		VISCORobo The VISCORobo is a fully automatic Viscosity and Melt Flow Rate Test Robot which feeds the test material into the test chamber automatically, performs the test and then cleans the test chamber, test piston and capillary. The VISCORobo 94.00 can be used to determine viscosity curves, the melt flow rate MFR in g/10min and the melt volume rate MVR in cm³/10min of plastic, granules, "gravel" and powder. The gravel and powder must be free-flowing.

[ Back ]

SEARCH

MI-Cleaning Boy

The MI-Cleaning Boy, a Melt Indexer with fully automated cleaning station (read more...)

Workshops 2010

The purpose of the workshops is to get the operators familiarized with the handling of the different hardware and its accessories, both, in pratice and theory with the purpose to qualify the operators to run reproducible tests, especially with test materials which are difficult to measure (more...)